9
7. Attach the Left Cap (19) and the Right Cap (20)
to the bottom of the Shroud (17) with two M5 x
20mm Self-tapping Screws (64) and two M5
Washers (72).
Attach the Top Cap (18) to the top of the Shroud
(17) with two M6 x 16mm Screws (62), four M6
Washers (82), and two M6 Locknuts (78).
7
18
62
62
82
78
82
17
20
19
64
72
72
6. Orient the Top Frame (4) with the welded support
on the bottom.
A
ttach the Top Frame (4) to the Upright (3) with
two M8 x 65mm Bolts (68), two M8 Washers (59),
a
nd two M8 Locknuts (58). Do not tighten the
Locknuts yet.
Attach the Top Frame (4) between the Weight
Guides (21) with an M10 x 155mm Bolt (74), two
M10 Washers (57), two 19mm Spacers (76), and
an M10 Locknut (56).
See steps 2–4, and 6. Tighten the M8 Locknuts
(58).
4
Welded
Support
3
58
5
6
74
21
21
59
5
7
57
59
76
76
68
58
6
To Next Page
Loading...
Need help?
General
