Weider 9025 - Seat Assembly; VKR Arm Pad and Back Pad Attachment; Seat Plate and Seat Attachment

14
31. Attach a VKR Arm Pad (64) to the Left VKR Arm
(13) with two M6 x 53mm Screws (70) and two
M6 Washers (69).
R
epeat this step with the Right VKR Arm (12).
32. Attach a VKR Back Pad (63) to the Rear Upright
(3) with two M6 x 65mm Screws (77) and two M6
Washers (69).
33. Attach the Backrest (61) to the Front Upright (3)
with two M6 x 65mm Screws (77) and two M6
Washers (69).
34.
Press a 38mm Square Inner Cap (29) into the
Seat Frame (7).
Attach the Seat Plate (28) to the Seat Frame (7)
with an M6 x 50mm Carriage Bolt (78), an M6
Washer (69), and an M6 Nylon Locknut (90) as
shown. Do not tighten the Locknut yet.
Attach the Seat (62) to the Seat Plate (28) with
two M6 x 16mm Screws (76). Next, attach the
Seat to the Seat Frame (7) with an M6 x 53mm
Screw (70) and an M6 W
asher (69).
Tighten the M6 Nylon Locknut (90).
31
32
33
34
64
1
3
12
69
69
70
7
0
63
3
69
77
61
4
69
69
77
77
62
78
28
29
7
76
69
90
70
Seat Assembly