Weider Powermax 70072 - Weight Stack Assembly

PAGE 13 WEIDER SPORTING GOODS
. STEP 5 WEIGHT STACK ASSEMBLY
| 2 |
az
ЕСІ
C] orient the GUIDE 9
RODS (9) so that А v
the bolt hole at а
the end of each 9
Guide Rod is to =
the top. Insert the zA Ve
Guide Rods into TT 10
the Guide Rod wW!
Plate welded atop \ г
сат»
the BASE GIF
FRAME (1). PINNING ЛАХ
ACCESS |
F
à
5%
ROUND
Tz
RUBBER
WASHER (98)
down over each
'Guide Rod and
position atop the
Plate.
О Working with опе
WEIGHT PLATE
(10) at a time,
stack nine Weight
Plates onto the
GUIDE RODS (9)
so the pinning
access slot in the
Weight Plate is
down and to the
front. Once the
Stack is complete,
check again to
make sure а!
Plates are
positioned
properly.
FRONT
GUIDE
ROD
lc
e
PLATE
|
di
f