Stripping and crimping machine Crimpfix 2.5 M
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19 5
3.5 Symbols and indications
Before switching on the machine, read through the operating manual carefully.
Use the machine only at dry places.
Caution!
This symbol indicates a possible hazardous situation.
Failure to observe these warnings could result in moderate injuries or property damages.
3.6 Training of personnel
• Only trained and qualified personnel are allowed to handle the machine.
• The responsibilities of the personnel for operating, changing tools and maintaining must defined.
• Only the manufacturer or authorized service workshops are entitled to repair these products.
3.7 Special obligations of the person in charge
• Knowledge about local regulations for safety and accident prevention.
• To take care that all safety and danger indications are clearly visible, replace them if necessary.
• To inform the manufacturer immediately if the machine and the application becomes unsafe.
• To change machine parts in defective condition immediately.
• To use only original spare and wear parts.
• Modifications or conversions at the machine require written approval by the manufacturer.
3.8 Using risks
• Operate the machine only when all safety system are fully functional.
• The operator is only allowed to clear faults on which the cover does not have to be removed.
• Only trained and qualified personnel are allowed to open the cover and to do maintenance or repair.
• Before opening the machine and changing spare parts remove the plug.
4. Transport
• Use always the complete original packaging for transports.
• For service and repair work the machine must be sent with all accessories.
• Before returning the machine, empty the stripping-waste container.
To Next Page
Loading...