The connection to u-create is interrupted, the controller re-
starts and the page SWUpdate is displayed in the browser.
SWUpdate page
If you are not automatically directed to the SWUpdate page,
simply reload the page.
▶ Drag the software update file into the dialogue window.
The upload then commences. The controller is subsequently
restarted.
8.5 Resetting the controller to default settings
The following data are reset:
– The current runtime application is removed.
– The controller is restarted.
– The IP address is reset to the standard IP address.
– The working copy is deleted.
▶ On the starting page, click Settings.
▶ Click Factory reset.
A dialogue window opens.
▶ Click OK.
The controller is reset to factory settings. The controller is
subsequently restarted.
8.6 Resetting the control to default settings
without password
You can also reset the controller to default settings without a
password e.g. if you have forgotten your password. To do this
you need physical access to the u-control station.
▶ Dismount all I/O modules from the u-control station.
▶ Connect your computer with the controller via USB.
▶ Start u-create web.
▶ When the password is requested, click Cancel.
▶ In the dialogue box which follows, click Resetting fac-
tory settings...
A warning appears.
▶ Click Restore u-control.
The controller is reset to factory settings. The controller is
subsequently restarted.
8 Commissioningusingu-createweb | Resetting the controller to default settings
61Manual u-control2604080000/03/08.2020
To Next Page
Loading...
Need help?
General
