55
January, 2017
TEST SETTINGS
The test settings section allows you to view your settings in operation before saving them to the
database. This will allow you to view the effect that each setting will have on the head sequence. Take
note that you will not be able to use these buttons if the PrimoCombi is in RUN or PAUSE mode.
Write Values to Primo – Clicking this button will send the current values for the General, Feeder,
Weigher, and Load cell settings to the PrimoCombi
Test Feeder Bucket – This will activate the Feeder Bucket.
Test Weigher Bucket – This will activate the Weigher Bucket.
Unless you are an advanced operator it is suggested that you test your settings prior to saving them.
To Next Page
Loading...
