99
January, 2017
CLEANING STEPS
1. USE OF CLEANING SOLUTIONS: It is important to be aware of the effects certain cleaning
products have on stainless steel and aluminum components.
Cleaners with excessive chlorine can damage the outer layer of stainless steel and
corrode it thus allowing it to rust.
2. RECOMENDATIONS: Do not pressure wash or run liquids over the machine. The machine is
designed to withstand indirect contact with water and liquids, such as splashing and damp
cleaning clothes. Avoid exposing the machine to water. If cleaning other equipment near the
machine, ensure that the machine is covered with an industrial water proof cover.
3. START: Begin by turning off the machine. Turn the Main Power Switch located on the Control Box
to the off position. Ensure that all components are cool to the touch before continuing.
When unplugging the machine, ensure that the power plug is carefully covered in order to
avoid exposure to moisture.
4. DISLODGE DEBRIS: Use compressed air to dislodge debris from components and clean the
electrical panel.
5. REMOVE AND CLEAN FOOD CONTACT COMPONENTS: Remove food contact
components including pans, buckets, chutes, funnel, center cone and the hopper so they may be
cleaned individually and away from the body of the machine.
Do not apply excessive force on components attached to the load cell as this may cause
damage to the load cell.
6. BODY OF THE MACHINE: Clean the machine with a damp cloth, this machine is not designed
to be washed down with a low or high pressure water hose; do not expose the machine to large
quantities water such as pouring water on the machine. Clean all metal surfaces thoroughly to
remove any contaminants. Use non-corrosive cleaning products.
7. TOUCH SCREEN: The machine comes equipped with an IP-64 rated Touch Screen by default,
although an upgrade may be purchased to equip an IP-67 Touch Screen in its place.
8. DRY COMPONENTS: Dry all components with a clean, dry cloth. No water spots should remain
on the machine. Leftover cleaning solution can cause damage to stainless steel surfaces.
9. REINSTALL COMPONENTS: Once cleaning is completed, reinstall all components.
10. END: Reconnect machine’s power plug if necessary. The machine is now ready to be powered
and run.
To Next Page
Loading...
