WM 67841c 03/2015
WM 100 TD EN 61
5 Operation
5.11.4 Sending the SD card
1. Remove the SD card (see "5.11.3 Removing the SD card",
page60).
2. Label the SD card with the name and date of birth in order to
avoid confusion when it reaches the physician or authorized
dealer.
3. Insert the SD card in the protective wallet included in the scope
of supply.
4. Send the SD card to the physician or authorized dealer.
5.11.5 Setting the device with the SD card
You can set the device with the help of an SD card provided by
your physician or authorized dealer.
Requirement • The therapy device is in the Standby mode.
1. Insert the SD card with the saved device settings (see "5.11.1
Inserting the SD card", page58).
Result The message Configuration via SD card was successful appears
on the display. You can continue the therapy with the new
settings.
If the new settings for your device were not suitable or could not
be read, the message Configuration via SD card has failed
appears on the display. Contact your authorized dealer to obtain
new settings.
The SD cards available from Weinmann have a field that you can
write in.
To Next Page
Loading...
Need help?
General
