62 EN WM 100 TD
WM 67841c 03/2015
6 Settings in the menu
6 Settings in the menu
You can configure settings for the comfort, accessories, and time
parameters in the settings menu when the therapy device is in
Standby mode.
6.1 Setting comfort parameters
Comfort parameters facilitate handling of the therapy device and
components for the patient and ensure a comfortable therapy.
Requirement The therapy device is in Standby mode.
1. Press the menu button .
2. Press the Comfort field.
3. Configure the desired settings and confirm.
Parameter Possible values Description
autoSTART-STOP
On
Off
Here you can activate/deactivate the automatic on/off function
autoSTART-STOP.
If the automatic on/off function is activated, you can switch the
therapy device on with a breath.
If there is no pressure for 5 seconds (e.g., because the mask has
been removed), the therapy device switches itself off again
automatically.
Mask test pressure
8hPa-20hPa
(depending on the
therapy pressure
currently set)
Here you can set the pressure at which the mask test is
performed (see "5.6 Performing a mask test", page 49).
Leaks due to a poorly sitting mask often only occur at higher
pressures.
softSTART
pressure
Intervals of 0.5 in
the range
prescribed by the
physician or
authorized dealer
(e.g., 4 hPa to
8hPa).
The softSTART function makes it easier to get used to the
ventilation pressure when falling asleep.
You can set the required softSTART pressure here.
If it is not possible to select this function, it must be enabled by
your physician or authorized dealer.
To Next Page
Loading...
Need help?
General
