Weinmann prismaAQUA User Manual

18
7.2 Filling with water
a. To open the respiratory air humidier, grip the lower recess on the
rear of the housing and press the rear of the housing gently with
your thumb.
b. Remove the top of the humidier.
c. If present: Pour out the water in the base of the humidier.
d. Fill the base of the humidier with fresh, cold water up to the
mark (max. 400 ml): Only use water with a low lime content or
distilled water.
e. Place the top of the humidier on the base of the humidier from
the back and press it on gently until it clicks into place.
7. Accessories: prismaAQUA respiratory air humidier
The prismaAQUA respiratory air humidier is used in combination with the therapy device in cases of dry upper airways and when the respiratory air is perceived as too
cold. prismaAQUA may only be used on the recommendation of a physician.
7.1 Preparation prior to rst use
Remove the protective transport paper and clean the respiratory air humidier as described under "7.6 Cleaning" on page 22.
a. + b.
d. e.

Weinmann prismaAQUA Specifications

General

Brand	Weinmann
Model	prismaAQUA
Category	Humidifier
Language	English