19
If you want to start the therapy but there is no
water in your prismaAQUA , the warning signal
appears after 30 seconds and the humidier
switches off automatically. Please then end the
therapy, ll the humidier, and start again.
a. Press the unlocking button on the therapy device.
b. Remove the respiratory air humidier from the side
of the therapy device.
Caution! Risk of injury from hot element!
During and shortly after operation, the element of the respiratory
air humidier is hot and touching it can cause burns.
Allow the element to cool down completely.
Avoid touching the element.
c.
Tilt the respiratory air humidier carefully
to the left and place it on its side.
d. Fill fresh, cold water up to the mark
(max. 400 ml) through the inlet:
Only use water with a low lime content
or distilled water.
e. Set the respiratory air humidier
upright again carefully.
f. Connect the respiratory air humidier to the therapy device and
start the therapy again.
7.3 Alternative lling
Below you can see an alternative lling method that you can use to rell the humidier quickly.
a. + b.
d.
To Next Page
Loading...
Need help?
General
