weinor BiEasy 15M Go! - Synchronised Transmitter Programming; Stopping Programming Mode; Setting End Positions

78 | EN Ⓒ weinor GmbH & Co. KG
4.6.2 Synchronised programming mode
For programming one transmitter to multiple receivers at the
same time:
1. Engage the DOWN and the programming P button (rear of
the device) simultaneously (for 3 seconds) on a transmitter
that has already been programmed to the receivers. The
statusdisplayashes.Thereceiversarenowinprogram-
ming mode.
2. Engage the programming button P on the transmitter
tobeprogrammeduntilthestatusdisplaylightsbriey.
The receivers are now in programming mode (ascents/
descents).
3. Immediately (no more than 1 second) after the curtain
starts moving upwards, press the UP button. The status
displaylightsbriey.Thecurtainsstopbriey,startmov-
ing again, stop and then move downwards.
4. Immediately (no more than 1 second) after the curtain
starts moving downwards, press the DOWN button. The
statusdisplaylightsbriey.Thecurtainsstopmoving.
The transmitter is now programmed.
4.6.3 Stopping programming mode in the transmitter
Engage the STOP button for at least 6 seconds until the
status display lights up orange.
4.6.4 Approaching the end position for roller shutters,
awnings, venetian blinds
Requirement:
The transmitter is now programmed. The end positions
are set.
BiEasy-15Mgo_weinor_BA_18112801_DE+EN_0218.indb 78 26.02.2018 13:50:48