weinor BiEasy 15M Go! - Deleting Transmitter

Ⓒ weinor GmbH & Co. KG EN | 79
Approaching the lower end position (roller shutter
or awning)
Engage the DOWN buttonbriey.Theblindapproachesthe
lower end position or the awning retracts completely.
Approaching the lower end position (blind)
Engage the DOWN button until the status display lights
briey.Theblindapproachesthelowerendposition.
OnlybrieyengagetheDOWN button (jog mode with YES
drive, pulse mode with Combio Pulse). The blinds starts
brieyandthenstopsagain.
Approaching the upper end position (roller shutter /
awning)
Engage the UP buttonbriey.Theblindapproachesthe
upper end position or the awning retracts.
Approaching the upper end position (blind)
Engage the UPbuttonuntilthestatusdisplaylightsbriey.
The blind approaches the upper end position.
Press the UPbuttononlybriey(jogmodeonYESdrive,
pulsemodeforCombioPulse),theblindapproachesbriey
and stops again.
4.6.5 Deleting the transmitter
Deleting the transmitter channel from the receiver
• Engage the STOP button as well as the programming
button P (on the rear of the device).
Keep this button combination pressed for approximately
6secondsuntilthestatusdisplaylightsorangebrieyand
then lights red.
The channel in the transmitter (or the group) is also deleted.
BiEasy-15Mgo_weinor_BA_18112801_DE+EN_0218.indb 79 26.02.2018 13:50:48