Installation- and operating manual Handling device HP140T R09-2011
36/52
Commissioning
6.2 Initial commissioning
6
6.2 Initial commissioning
If a Pick & Place is delivered with amplifier and software, the commissioning will be car-
ried out via the Weiss Application Software (WAS).
Further information on this can be found in the electrical and software documenta-
tion for the HP140T.
6.3 Recommissioning
Risk of injury emanating from an operationally unsafe machine.
An operationally unsafe machine can cause injuries and material damage. Recommis-
sioning should only be realised after it has been ascertained that the machine is in a
functionally reliable condition and no risk emanate from it during operation.
A visual inspection of the machine should be conducted prior to re-commissioning. The
following should be checked and ensured in this regard:
• No damage is present on the machine.
• No foreign materials, tools or other objects are lying in the operating area of the
machine.
• All supply units are connected and operating.
• Safety equipment is ready for operation.
To Next Page
Loading...
