WEISS
Installation- and operating manual Handling device HP140T R09-2011
5/52
Introduction
1.1 Definition
1
1Introduction
1.1 Definition
Mechanical system documentation
Handling device HP140T
The Pick & Place is a handling device with direct motor-driven axles.
In the following, the Pick & Place will be referred to as "machine".
1.2 Correct use
The machine is a noncomplete machine conforming to Directive 2006/42/EC,
Article1gand2g.
The machine is designed for integration in other machines, in other incomplete machines
or equipment or for connection to these.
It may only be used within the limitations defined in the order characteristics.
Commissioning is forbidden until the conformity of the product in which the machine is
installed with Directive 2006/42/EC and all other Directives governing use has been
determined and confirmed.
Observance of the accompanying documentation and adherence to maintenance
regulations are also component parts of correct use.
1.3 Incorrect use
Any use of the machine above or beyond the directions for correct use is regarded as
incorrect and prohibited.
The machine must not be subjected to loads that exceed the maximum limits.
The machine is not suitable for use
• in wet or damp environments of any kind (water, oils, acids, steam or vapours, etc.).
• in an environment with gases or radiation.
• in potentially-explosive atmospheres.
• in environments which contain swarf.
1.4 Laws / EC Directives / Norms
The machine is designed and constructed to conform to
• applicable laws
• Directive 2006/42/EC (Machinery Directive)
• Low Voltage Directive, 2006/95/EC
• EMC Directive 2004/108/EC
• and the harmonised standards that we have cited
and meets state-of-the-art technological standards in terms of its construction.
To Next Page
Loading...
Need help?
General
