Note One gram (0.001 kg) is equal to 1 cc of liquid. (1.0 specific
gravity).
To ensure the most accurate measurements, do the following:
• Perform the procedure each time a urine output measurement is needed.
• Do not rely on subtracting a known weight for a dry diaper from the displayed weight
of a wet diaper.
• Remove any fecal matter from the wet diaper before starting the weighing
procedure. The change in the dry and wet diaper should only reflect urine content.
Send measurements to a computer
The scale can connect to a computer using the Microsoft
®
Windows
®
10 operating
system.
Detailed instructions for this feature are available from Welch Allyn. Go to http://
www.welchallyn.com/en/other/contact-us.html to find your local representative.
CAUTION Any computer connected to the scale must be running on
battery power, a 60601-1-compliant power supply, or a 60601-1-compliant
isolation transformer.
1. Connect the USB Type B male side of the cable to the USB port on the rear of the
scale.
2. Connect the USB Type A male side of the cable into a USB port on your computer.
Windows automatically installs the necessary driver.
3. Press SEND DATA on the scale to send the current measurement to the computer.
Send measurements to a Welch Allyn device
The scale can connect to a Welch Allyn Connex
®
Vital Signs Monitor or a Welch Allyn
Connex
®
Spot Monitor.
CAUTION Any device connected to the scale must be running on battery
power, a 60601-1-compliant power supply, or a 60601-1-compliant isolation
transformer.
1. Connect the USB Type B male side of the cable to the USB port on the rear of the
scale.
2. Connect the USB Type A male side of the cable into a USB port on the rear of your
device.
3. Press SEND DATA on the scale to send the current measurement to the device.
12 Scale operation Welch Allyn Pediatric/Infant Scale
To Next Page
Loading...
