Welch Allyn 5002 - USB Details

25
6. The follow error messages may show:
Error Message
Meaning
ER ZR0
Reading is outside the scale type’s acceptable mV/V range.
ER ZR1
Calibration message failed to send.
ER ZR2
There was an error while waiting for the scale to calibrate.
ER ZR3
The calibration did not save.
ER OL
The span weight was greater than the capacity weight of the
scale.
ER SP1
The span weight was outside the acceptable span margin for
the given mV/V reading.
ER SP2
Calibration weight message failed to send.
ER SP3
Does not currently exist.
ER SP4
Calibration weight message failed to send.
ER SP5
There was an error while waiting for the scale to calibrate.
This can occur if the user presses the Zero key while
calibrating, or if the measurement board has an internal
error.
ER SP6
The calibration did not save.
If an error occurs, press
the LB/KG key to exit back to the Calibration options. Retry the calibration.
If the error continues see the disassembly and troubleshooting section to identify.
USB Details
For detailed help and information regarding the data output capabilities, contact Welch Allyn.