EasyManua.ls Logo

Welch Allyn Connex Spot Monitor - Page 142

Welch Allyn Connex Spot Monitor
166 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SpO2 specifications (Masimo specifications, see footnotes 1, 2, 3, 4, 5, and 6)
No motion: ± 3 digits
Motion: ± 5 digits
Saturation
Note
Saturation accuracy varies by sensor type. Refer
to the sensor Directions for use for additional
accuracy information.
60% to 70%
Adults, Neonates: ± 3 digits
Nellcor sensor accuracy guide
7, 8
SpO2 measurement accuracy can only be evaluated
in vivo by comparing pulse oximeter readings with
SpO2 measurements obtained from simultaneously
sampled arterial blood made using a laboratory CO-
oximeter. SpO2 accuracy was validated through
breathe-down-equivalent testing by Covidien using
electronic measurements to prove equivalence to
the Nellcor N600x predicate device. The Nellcor
N600x predicate device was validated by
performing human-subject, “breathe-down” clinical
trials.
Pulse rate 25 to 240 beats per minute (bpm) ± 3 digits (no
motion)
Saturation
Note
Saturation accuracy varies by sensor type.
70% to 100%
Adult, neonate: ± 3 digits
Low Perfusion: 0.02 % to 20 % ± 2 digits
Detected pulse rate 20 to 250 beats per minute (bpm) ± 3 digits
Nonin sensor accuracy guide
SpO2 accuracy testing is conducted during induced
hypoxia studies on healthy, non-smoking, light-to-
dark-skinned subjects during motion and no-motion
conditions in an independent research laboratory.
The measured arterial hemoglobin saturation value
(SpO2) of the sensors is compared to arterial
hemoglobin oxygen (SaO2) value, determined from
blood samples with a laboratory co-oximeter. The
accuracy of the sensors in comparison to the co-
oximeter samples measured over the SpO2 range of
70 – 100%. Accuracy data is calculated using the
root-mean-squared (A
rms
value) for all subjects, per
ISO 9919:2005, Standard Specification for Pulse
Oximeters for Accuracy.
Perfusion
40–240 BPM. Adult/Ped = +/- 3 digits; Neonate =
+/- 3 digits
Pulse rate 18 to 321 beats per minute (bpm)
No motion (18 to 300 bpm): ± 3 digits
Motion (40 to 240 bpm): ± 5 digits
Saturation
Note
Saturation accuracy varies by sensor type.
70% to 100%
Adult/Pediatrics
No Motion
70% to 100%
Neonates
No Motion
Finger Clip: ± 3 digits
136 Specifications Connex
®
Spot Monitor

Table of Contents

Other manuals for Welch Allyn Connex Spot Monitor

Related product manuals