EasyManua.ls Logo

Welch Allyn Connex Spot Monitor - Controls, Indicators, and Connectors; Front-Left View

Welch Allyn Connex Spot Monitor
166 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Setup
Supplies and accessories
For a list of all approved supplies and accessories, see
Approved Accessories in the
Appendices.
WARNING Patient injury risk. Clean all accessories, including cables and
tubes, before storing the accessories on the device or cart. This helps
reduce the risk of cross contamination and nosocomial infection. Refer to
'Clean the equipment' in "Maintenance and service" for directions.
Connect the battery
This procedure applies to first-time setup of the monitor. The battery is inserted in the
battery compartment when you receive a new monitor. However, it is not connected.
WARNING Personal injury risk. Improper handling of the battery can lead
to heat generation, smoke, explosion, or fire. Do not short-circuit, crush,
incinerate, or disassemble the battery. Never dispose of batteries in refuse
containers. Always recycle batteries according to national or local
regulations.
WARNING Use only Welch Allyn approved accessories, and use them
according to the manufacturer’s directions for use. Using unapproved
accessories with the monitor can affect patient and operator safety and can
compromise product performance and accuracy, and void the product
warranty.
1. Set the monitor on a flat surface with the screen facing downward to access the
battery cover.
19

Table of Contents

Other manuals for Welch Allyn Connex Spot Monitor

Related product manuals