Welch Allyn Connex - Set the Date and Time; Set the Default Configuration

18 Startup Welch Allyn Connex® Integrated Wall System
Set the date and time
1. Touch the Settings tab.
2. Touch the Device tab.
3. To change the date and time values, touch the up and down arrow keys or touch
and enter a value.
Repeat for each value you want to change.
Set the default configuration
1. Touch the Settings tab.
2. Touch the Device tab.
3. Enter or adjust the desired settings you want to add or change.
4. Touch Save as default.
5. Touch OK to confirm that you want to overwrite your previous settings and replace
them with your current settings in the startup default configuration. Or touch Cancel
to retain the previous settings.
The new settings are stored as the default startup settings once you restart the monitor.
Note
The date and time stamps on saved patient measurements will adjust in response
to new date and time settings.
Note
The
The new settings appear as they are completed but are temporary until they are
saved.
Note
If your wall system is connected to a network, the date and time settings are
synchronized with the network settings.
Note
The date and time stamps on saved patient measurements will adjust in
response to new date and time settings.