8 Welch Allyn
Charging the illuminator
Charge the illuminator before using it the first time, or whenever
its low-charge indicator turns on.
To charge the illuminator
1. If LED is lit, turn power switch off.
2. Connect charging base to AC power.
3. Place the illuminator (either direction) into the charging
station. Full charging takes 6 to 8 hours.
4. Remove the charged illuminator when you are ready to use it.
It is safe to leave the illuminator in the charging station after it
is charged.
Low-charge indicator:
On = battery low
Power switch
LED
Status indicator:
Off = no AC power
Green (no illuminator) = AC power
Amber (illuminator inserted) = charging
Green (illuminator inserted) = charged
To Next Page
Loading...
