Welch Allyn ProBP 2400 - Selecting units of measure

14
Selecting units of measure
1) Make sure the device is switched off.
2) Press and hold the M Button and then turn on the
power with the On/Off Switch.
3) Release the M Button when backlight illuminates.
4) Press the Start/Stop Button to select the preferred
pressure unit (mmHg or kPa).
5) Press M Button to conrm the selection.
Units
MAP or
PAM
1
mmHg MAP
2
mmHg PAM
3
kPa MAP
F
MAP is the abbreviation of Mean Arterial Pressure.
F
PAM or MAP is chosen depending on language preference.
Initial set up (cont.)
F
Factory default setting