CMP203 User Guide
The second eth is reserved for you to output IP streams in an another different VLAN. You can
output unicast streams to the another VLAN by enabling the second eth and setting IP Address,
Subnet Mask, Default Gateway in the same segment of the unicast IP (the another different VLAN).
To use Multiplexing mode on service level
1. Click on the pencil icon . There will always be a BaseBoard selection for the IP output and
other Output options depending on the modules inserted.
2. Select the correct Output and Channel you want to output the Service to.
3. Check Multiplex for the Channel you want to output through. You can output multiple services
in the same channel or output the same service in multiple channels.
To use RTMP output to configure streaming to any website capable of receiving RTMP, it is
necessary to create a new stream instance on the intended receiving platform and enter the
corresponding URL and port.
CE2-HDMI-R01 >Insertion (only available in the CE2-HDMI-R01 module)
You should choose a channel first before you set Insertion.
To Next Page
Loading...