15
®
www.wellbox.com
Starting-up
Before using your Wellbox, we recommend reading the installation
instructions.
1. After connecting the power (see page 14), press the
key to turn on the device.
The control panel lights up. Before starting the treatment and according to the in-
structions in this Installation and User Guide, you must select:
• The intensity (Power)
• The treatment continuous or rhythmic program (Select)
• The duration of treatment (Time)
When you use the machine for the first time, all parameters are set at the lowest
values:
- Minimum intensity at . Press on to increase
- Suction mode on Continuous
. Press on to switch to rhythmic mode
/
/ (low/medium/high).
- Time at 6’
06’00
. Press or to select the required duration for treatment.
2. Select the head to use and then adjust the power settings, continuous or rhythmic
program, and duration by referring to the Instructional poster.
3. Press
start
stop
to start the treatment. If the Roll head
is connected, the rollers are
moving forward when the treatment begins. A lit arrow indicates the head’s moving
direction. Press the trigger to reverse the direction. The lit arrow will also change
(see page 11).
4. You can interrupt the treatment at any time and resume when you want by
pressing
start
stop
.
5. To close your Wellbox after use:
- Connect the Roll head to the hose.
- Roll the hose into the tube designed for this purpose (two times around).
- Place the Roll head
in the location next to the control panel. Store the other
heads in their location in the top lid
.
Your Wellbox automatically turns off after five minutes of non-use.
ensemble chapitres.indb 15 11/05/11 12:09
To Next Page
Loading...