17
®
www.wellbox.com
Roll heads
maintenance
To clean
the
Roll heads :
1 . Hold the head by the roller side.
Remove the rollers by pushing them out.
2 . Remove the seal from treatment chamber.
3 . Carefully clean the treatment chamber, the seal
and the rollers with a wipe.
4 . Put the seal back in place.
5 . Push the rollers back in until you hear a “click”.
1.
3.
5.
3.
4.
To clean
the Roll head :
1 . Holding the head in one hand, unclip the
protective parts from each of the rollers
and clean them using a wipe.
2 . Remove the two seals by delicately
removing them from their groove and then
clean them carefully using a wipe.
3 . Clean the treatment chamber and the rollers
with a wipe.
4 . Clip the protective parts to the forked seals
and place both parts into the head. Apply slight
pressure to the grooves to put everything into
place.
4.
2.
1. 1.
3.
For reasons of hygiene, the treatment heads must be cleaned
regularly before and after every use, with the heads disconnected, using
the supplied wipes or wipes soaked with an antiseptic, bactericidal and
fungicidal solution.
2.
ensemble chapitres.indb 17 11/05/11 12:10
To Next Page
Loading...