31
TESTING YOUR BLOOD GLUCOSE
TESTING YOUR BLOOD GLUCOSE
After every turning on of the meter it will perform a system check automatically.
Materials you will need:
Your Wellion CALLA Light Meter
A new Wellion CALLA Blood Glucose Test Strip
Lancing device with a clean, unused lancet
Before you begin, make sure:
• Set up your meter properly and run a control test. See Setting Up Your New Sys-
tem on page 11, and Control Solution Testing on page 26, for details.
• Wash your hands and testing site thoroughly with soap plus warm water, and dry
well.
• You are testing in an area between the temperature ranges of 10°C to 40°C. Your
meter will not test outside of this range and will display . Make sure that you
perform the test in a temperature range between 10°C to 40°C and wait for 10 to
15 minutes before testing again.
To Next Page
Loading...
