OPERATION
OPERATING THE DRYWALL SANDER
1. Hold the machine firmly with both hands. DO NOT
hold the machine by the machine’s head to avoid injury.
2. Before operation, make sure every fastener and nut
has been properly engaged and that the sanding pad has
been properly installed and aligned.
3. Before switching on the machine, keep the sanding
head slightly away from the work surface.
5. During sanding operation, do not press down too hard
in order to avoid overloading the sander. Use proper
pressure for better sanding effects. If the machine slows
or bogs down, immediately lessen the applied pres-
sure. The quality of the results are mainly determined by
choosing the right abrasive material for the job.
WARNING! This tool is for indoor use only. DO NOT expose to rain or use in damp locations.
6. Once the sanding task has been completed, turn off the machine. Wait for the pad to stop rotating before setting
down the machine.
VARIABLE SPEED CONTROL
Use the variable speed adjustment wheel (Fig. 7 - 1) to adjust anywhere from 600 to 1500 RPM. This drywall sander
is equipped with constant speed control to keep the pad running at a consistent rate despite changes in applied
load.
TURNING ON THE DRYWALL SANDER
After setting the variable speed to your desired RPM, power the machine by pressing forward on the power switch
(Fig. 7 - 2).
Fig. 7
1
2
12
To Next Page
Loading...
Need help?
General
