19
MAINTENANCE
GENERAL MAINTENANCE
1. Clean your saw after each use. Wipe it down with a soft cloth. Clean any accumulated sawdust out of the base.
Use low-pressure compressed air (not to exceed 25 PSI) to blow any sawdust out of the blade holders, blade bevel
rails, etc.
2. If desired, apply a light coat of dry lubricant (such as PTFE) to the inside of the blade bevel rails. This will help
the table bevel smoothly.
3. The motor bearings, interior bearings, and table bevel rail bearings are all sealed and require no additional lubri-
cation.
WARNING! Always turn the switch OFF and unplug the power cord from the outlet before maintaining or
lubricating the scroll saw.
To Next Page
Loading...
Need help?
General
