OPERATION
AUTOMATIC FEED
Once you have the cross slide set in position double check the following:
1. The auto feed direction lever is set to FORWARD.
2. The auto feed lever is disengaged from the lead screw.
3. You are in the appropriate speed selection range of HIGH/LOW.
4. The gear train is in the proper configuration, as this determines the feed rate of the lead screw. The factory setting
is okay for normal turning, but if you have been cutting screw threads you will need to reset the gear train to the
proper configuration.
CUTTING WITH THE AUTOMATIC FEED
NOTE: Ensure the DOC is appropriate for the cutting tool material, workpiece material, etc.
1. Position the cutting tool past the end of the workpiece, away from the tailstock. Make sure the tool is set to the
proper cutting depth. Always do shallow cuts, as cutting too deep too fast will damage the work piece, your cutting
tool, and your lathe. It is recommended to keep the cuts to 0.010” (0.25mm) or less at a time.
2. Double check that all the feed levers are set properly.
3. Turn the unit ON and set the spindle speed to the desired rate. Push the autofeed lever down to engage the half
nut with the lead screw.
4. Watch your cutting tool. When it reaches the end, quickly press UP on the auto feed lever and make sure it stays
disengaged from the lead screw.
5. Retract the cutting tool one or two turns using the cross slide handle. Feed the carriage back to the starting point,
and feed the tool back in one or two turns plus the additional cutting depth.
6. When ready for the next pass, engage the auto feed lever and repeat the previous steps until you have removed
the desired amount of material.
17
To Next Page
Loading...
Need help?
General
