Things to remember when operating the wireless remote control
• You may have to increase the timer switch setting
during the setup procedure, if there are interruptions�
• If the timer switch turns o before you are nished with
the remote control:
1� Turn the timer switch back on�
2� If the stabilizing jacks are already lowered into
position, you must press the red auto level button
again to regain use of the roof/canopy raise function
and the stage function�
• Turn the transmitter switch o when not in use, to save
battery power�
• When the performance is complete, you will probably
have to turn the timer switch back on (see the previous
note) before you can close up the Showmobile�
• Turning the transmitter switch o and on doesn't change
anything on the Showmobile�
• If you ever need to completely disable the hydraulic
system on the Showmobile, press the red lockout button
on top of the remote control� To activate the remote
control, turn the transmitter switch o and then on.
• You can lower the roof/canopy at any time by turning
the transmitter on and pressing lower roof/canopy�
• The roof/canopy will not raise unless the chassis is level�
12
Roof Limit
Switch
Leveling the Showmobile (continued)
To Next Page
Loading...
General