9. Carefully lower the Handrails (55, 56) to the floor. Center
the Frame (51) between the Handrails, and tighten the
four M10 x 58mm Bolts (2) (see step 1). Then, raise the
Handrails back to the vertical position.
See the inset drawing. Attach the Latch Assembly (102)
to the Left Upright (53) with two M4.2 x 16mm Screws
(7). Make sure that the Latch Assembly is oriented
as shown.
See HOW TO CHANGE THE INCLINE OF THE TREAD-
MILL on page 15. Adjust the incline of the treadmill as
desired.
10. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking
belt (see page 19). To protect the floor or carpet, place a mat under the treadmill.
102
53
7
8. Set the Console Assembly (91) on the Right Upright (54)
and the Left Upright (not shown). Next, start four M8 x
70mm Bolts (3) with four M8.5 Washers (13) and four
M
8 Star Washers (10) (only two of each are shown) into
the Right Upright and the Left Upright. Then, tighten all
f
our Bolts.
Insert the slack in the Wire Harness (98) down into the
Right Upright (54).
Attach the Console Back (93) to the Console Assembly
(91) with four M4.2 x 16mm Screws (7). Make sure that
the Wire Harness (98) is in the indicated slot in the
Console Back and that no wires are pinched.
91
54
7
7
7
10
98
Slot
13
3
93
8
9
55, 56
51
2
10
To Next Page
Loading...
Need help?
General