Westerbeke 12C- TWO User Manual

PREPARATIONS FOR INITIAL START-UP
PRESTART INSPECTION
Before starting your engine for the first time or after a
prolonged layoff,
check the following items:
o Check the engine oilleve!. Add oil to maintain the level
at the high mark on the dipstick.
OThman the fuel supply, then check the fuel supply and
examine the fuel filter/water separator bowl for
contaminants.
o Check the transmission fluid leve!.
o Check the DC electrical system. Inspect wire connections
and battery cable connections. Make certain the positive
(+) battery cable is connected to the starter solenoid and
the negative (-) cable is connected to the engine ground
stud (this location is tagged).
o Check the coolant level in both the plastic recovery tank
and at the manifold.
NOTE: If the engine has not yet been filled with coolant,
refer to the COOLING SYSTEM section of this manual.
D Visually examine the engine. Look for loose or missing
parts, disconnected wires, and unattached hoses. Check
the threaded connections and engine attachment~.
D Make certain there is proper ventilation around the
engine. An ample supply is necessary for proper engine
perfonnance.
D Make sure the mounting installation is secure.
,
D Ensure the propeller shaft is securely attached to the
transmission.
D . Open the thru-hull and make certain raw water is primed
to the raw'water strainer.
TOP 'OIL FILTER
CHECK ENGINE
OIL LEVEL
LOW
. I . .
CHECK TRANSMISSION FLUIO.
CHECK COOLANT LEVEL
~ WESTERBEKE
Engines & Generators
8

Westerbeke 12C- TWO Specifications

General

Brand	Westerbeke
Model	12C- TWO
Category	Engine
Language	English