Westerbeke 12C- TWO User Manual

HURTH HBWJZF TRANSMISSION TROUBLESHOOTING
Problem
Probable ~ause Verllicalion/Remedy
High fluid temperature.
1.
Fluid level high during operation.
1;
Pump out fluid to the maximum and mark on' dipstick.
2. Fluid level low.
·2.
Add fluid. '.' ,
3.
Plugged or restricted fluid coole,
3.
Replace cooler and flush water system,
4. No walerJn 'cooling system. 4. Check cooling system and repair.
5. Filter cill\lged (If applicable).
5.
Replace element.
Fluid on transmission housing.
1. Loose screws. 1.
Tighten to specification. '
2.
Loose screw connections.
2.
Tighten, replace.
3. Loose dipstick.
3.
Tighten; replace.
4. Loose fluid filter. 4. Tighten, replace.
5.
Fluid level high during operation.
5.
Pump out fluid to the maximum and mark on dipstick.
Fluid and water mixed; shifts hard.,
1. Damage to fluid cooler •.
1.
Replace cooler and flush transmission and hoses.
·2.
Selector coritrollinkage.
2.
Refer this manual.
Slow engagement.
1. Selector control. 1. Refer this manual.
2.
Low fluid level. 2. Add lIuid.
3.
Linkage. 3. Adjust (refer this manual.
No movement of the boat.
1.
, Selector control. 1. Consult service station.
2-
Improper selector position. 2. Adjust (see this manual).
3.
Low fluid level. ,3. Add fluid.
4.
propeller missing. 4. Replace.
5. Prop,ellershaft broken. 5. Contact marlne repair,
6. 'Transmisslon malfunction.
6. Contact manufacturer.
7. Engine maHunction .. 7. Contact marine repair.
NOTE: If you suspect a major problem in your transmission, immediately contact your WESTERBEKE dealer or all authorized
marine transmission facility,
-..Y' WESTERBEKE
Engines & Generators
50

Westerbeke 12C- TWO Specifications

General

Brand	Westerbeke
Model	12C- TWO
Category	Engine
Language	English