Westerbeke ATOMIC 4 User Manual

SPARK PLUG'S
-4 #3 #2
NOTES :-
LEAD CD IS CUSTOMER INSTALLED. USE MIN. OF "I
HEAVY DUTy BATTERY CASLE. THIS WIRE MUST BE
GROUNDED BACK TO ENGINE.
LEAD @ IS CUSTOMER INSTALLED. USE MIN. OF MI
HEAVY OUT { BATTERY CABLE.
LEAD (3'\ IS Cu:;TOMER INSTALLED. USE MIN. OF #8 WIRE.
Wiring Diagram - Motorola
Alternator - 12 volt -
35 ampere - Solid State Regulator
OC NOT IN:;TALL THIS WIRE IF A PANEL MTD. AMMETER
IS USE~.
ALTERNATOR, REGULATOR, ~ START. MOTOR ARE GROUNDED
TO ENGINE AT FACTORY.
ALTERNATOR FIELD IS INTERNALLY CONNECTED UNDER
REGULATOR.
BACK SIDE
((---
OIL PRESS.
OF 3 UNIT A\NEL
I~N~ r-®~==+--. "\
~ ( 1 I
AMMETER
Figure 4
*OIL TUBE
3 Unit Instrument Panel
Figure 5
TO BATT. + TERMINAL
TO T TERMINAL
OF IGN. COIL
ON START MOTOR SOLENOID
STARTER SWITCH (NOT a
FURNISHED BY U. M.CO.
TO ALT. OUTPUT TERMINAL
ON ALTERNATOR
TO "S" TERMINAL ON
NOTES:- S TART MOTOR SOLENOID
LEADS CD lIRE CUSTOMER INSTALLED. USE #8 GA. WIRE ~
CIRCUITS UNCER 15 FT., *6 GA. \MRE ~ ClRCUTS FR(J.1
15 TO 25 FT.
LEADS
<Zl ARE CUSTOMER INSTALLED, USE #16 GA. WIRE FOR
CIRCUITS UNDER IS FT •• #14 GA. WIRE FOR CIRCUITS FROM
IS TO 25 FT.
* WHEN NON-METALLIC FLEXIBLE OIL TUBE IS USED GROUND
INSTRUMENT ~NEL DIRECTLY TO ENGINE.
-17-

Westerbeke ATOMIC 4 Specifications

General

Brand	Westerbeke
Model	ATOMIC 4
Category	Engine
Language	English