Lit. No. 49513, Rev. 00 76 August 15, 2011
REMOVING SNOWPLOW FROM VEHICLE & STORAGE
1. After lowering blade and turning control OFF,
disconnect the electrical plugs.
During the off-season, the control can be
removed. Disconnect the connector in the cab and
store the control in the glove box of the vehicle.
• Drive the vehicle to the desired snowplow
storage location.
• Adjust straight and WIDE-OUT™ blades to the
straight position or MVP PLUS™ blades to the
fully retracted (vee) position.
• Lower the blade to the ground.
• Turn the vehicle ignition to the "OFF" position.
CAUTION
On 2-plug electrical systems, plug covers
shall be used whenever snowplow is
disconnected. Vehicle Battery Cable is
12-volt unfused source.
To Next Page
Loading...
