Wfly RF206S - Receiver and Servo Connection Example - Airplane

Basic Operation
Receiver and servo connection example - Airplane
The figure below shows an example of airplane connection. Please use the actual wing type and tail type
for servo connection.
Servo connection position (Airplane,refer to stick mode "Mode 1")
The table below shows examples of the servo connection positions for the different wing types and
tail types(system default settings)
16
CH1/Aileron
CH2/Elevator
CH3/Throttle
CH4/Rudder
CH5/Gear
CH6/Aux1
Type Wing Delta wing Tail CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Channel AIL ELE THR RUD Gear AUX1 AUX2 AUX3
Control J1 J3 J2 J4 SD -- -- --
Trim T1 T3 T2 T4 -- -- -- --
Channel AIL ELE THR RUD Gear AUX1 AUX2 AUX3
Control J1 J3 J2 J4 SD -- -- --
Trim T1 T3 T2 T4 -- -- -- --
Channel AIL ELE THR RUD Gear 升降2 AUX2 AUX3
Control J1 J3 J2 J4 SD -- -- --
Trim T1 T3 T2 T4 -- -- -- --
Channel AIL ELE THR RUD Gear AIL2 AUX2 AUX3
Control J1 J3 J2 J4 SD -- -- --
Trim T1 T3 T2 T4 -- -- -- --
Channel AIL ELE THR RUD Gear AIL2 AUX2 AUX3
Control J1 J3 J2 J4 SD -- -- --
Trim T1 T3 T2 T4 -- -- -- --
Channel
AIL ELE THR RUD ELE2 AIL2 AUX2 AUX3
Control J1 J3 J2 J4 -- -- --
Trim T1 T3 T2 T4 -- -- -- --
Channel AIL AIL2 THR RUD Gear ELE AUX2 AUX3
Control J1 -- J2 J4 SD J3 -- --
Trim T1 -- T2 T4 -- T3 -- --
Channel AIL AIL2 THR RUD RUD2 ELE AUX2 AUX3
Control J1 -- J2 J4 -- J3 -- --
Trim T1 -- T2 T4 -- T3 -- --
Airplane
1 AIL Normal
2 AIL Normal
1 AIL V-Tail
1 AIL Ailevator
2 AIL V-Tail
2 AIL Ailevator
2AIL Normal
2AIL Winglet