Wfly RF206S - Receiver and Servo Connection Example - Helicopter

Basic Operation
Receiver and servo connection example - Helicopter
The figure below shows an example of helicopter connection. Please use the swash type that is actually
used for the servo connection.
Swash Types
H-1
Normal
HR3(120°)
PIT
AIL
ELE
17
Servo connection position (Helicopter,refer to stick mode "mode 1")
The table below shows examples of the servo connection positions for different swashes.
GRO
CH1/Aileron
CH2/Elevator
CH3/Throttle
CH4/Rudder
CH5/Gyro
CH6/Pitch
Type Swash CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Channel AIL ELE THR RUD Gyro PIT AUX2 AUX3
Control J1 J3 J2 J4 -- J2 -- --
Trim T1 T3 T2 T4 -- -- -- --
Channel AIL ELE THR RUD Gyro PIT AUX2 AUX3
Control J1 J3 J2 J4 -- J2 -- --
Trim
T1 T3 T2 T4 -- -- -- --
Helicopter
H-1
HR3