Receiver and servo connection example - Multicopter
This figure is for illustrative purposes only. Link amplification also changes depending on the multicopter
collective and the flight controller. Please connect according to the instruction manual of the multicopter kit
to be used.
Servo connection position (Multicopter,refer to stick mode"Mode 1")
The figure below shows the four-rotor multicopter. Please refer to the model manual for specific
applications. Motor,electronic speed controller, flight controller, battery, etc. are sold separately.
Use 5CH-6CH when using accessories such
as camera shutters. Use a W.BUS interface or
dual receiver when the channel is insufficient.
Battery
Motor、ESC
（buy seperately）
CH1 Aileron
CH2 Elevator
CH3 Throttle
CH4 Rudder
CH5
Multicopter
flight controller
18
Basic Operation
Type CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Channel AIL ELE THR RUD Flight mode AUX1 AUX2 AUX3
Control J1 J2 J3 J4 -- -- -- --
Trim T1 T2 T3 T4 -- -- -- --
Multicopter
To Next Page
Loading...