10
Replacement the throttle of mode 1 or 2
Bolt 1.
Bolt 2.
Bolt 3.
Bolt 4.
Set up release link and
springer,according your habit
to adjust the tightness of screw
2 to adjust the control felling.
Put on the matel
chip,according your habit to
adjust the elasticity of screw 3
and screw 4 to adjust the damp
of throttle control felling.
Take the metal chip and
screw down,and put it on
the similar position of the
right side.
Take release link and spring
Down,and put it on the left side of the
location of corresponding,then twist
bolt1 down until withstand the adjust
nail ,in case adjust nsil will move away.
INSTRUCTION MANUAL
WFT07 REMOTE CONTROL DEVICE
Right-hand man will lose their own free replacement warranty program
To Next Page
Loading...
