18
5. Use the arrow keys to select the curve point, + / 6. Set successfully, you can press EXIT key to
- key to changing the value of curves point. return.
4. Settings exponential EX, can change the combinations and settings, with the arrow keys to
aileron, throttle and rudder these three channels' select the "EX" in the screen, settings way are same
joystick sensitivity near the neutral. Dual rate and as "D / R" .
curve exponential are match, will have a lot of
3.Servo Reverse
●Function
●Settings
Servo reverse function can adjust the direction of movement is normal or reversed.
the servo moves to make the direction of servo
In the "Preferences" interface,use Up / Down keys item.
to choose "Servo reverse", press OK key to 2. with + / - keys to switch the action is normal or
confirm enter the function interface.As above.The reverse and use the OK keys to implement.
steps of settings is as follows: 3. Set successfully, press EXIT key to return.
1. First to use the arrow keys to select the edited
4.End Point
●Function
●Settings
End point function can determine the end point of route of servo movements, the adjustment range is
the servo's initial value, adjusting the largest between 0% -120%.
In the "Preferences" interface,use up / down keys keys to select the edited items.
to select the "End point" and press OK key to enter 2.Set the value of the route with + / - key. Long press
the function interface, as above. The steps of OK key to restore the default values.
3. Set successfully, press EXIT key to return.
settings is as follows: 1.First use the arrow
Helicopter Functions
INSTRUCTION MANUAL
WFT07 REMOTE CONTROL DEVICE
To Next Page
Loading...
