If you want to use the X4 high speed steering response mode, you must
meet the following conditions:
With the 6V 270Hz specifications: digital servos.
The 6A nickel cadmium battery the using power for the receiver .
The transmitter steering response mode setting: high speed mode
(refer to page 53).
When using the simulated steering, be sure to transform the response
mode of X4 steering into the normal mode .
The use of X4 common steering response mode, must meet the following
conditions:
With the 6V 50Hz specifications: Simulation of steering gear.
The use of nickel cadmium battery power receiver: 6V.
The transmitter steering response modes: normal mode
(refer to page 53).
Simulation of steering gear can not normally operate in the high-
speed mode ,
And also can connect to the steering of the receiver and other part may
happen failure .
In normal mode, digital servos also can normally operate ..
13
Warning
Attention For The Mode Setting Of Steering Response
Terms Of Use
To Next Page
Loading...
