System Settings
Adjustment
When the throttle and steering wheel will make the mechanical deviation, use calibrational
function to correct.
Setting method:
1,According to "neutral" prompt, put the trigger, the runner on the midpoint,
press the confirm key.
2,According to the prompt "endpoint" , put the trigger ,wheel into the midpoint
struck several times respectively ( lightly lean is ok, as the following graph), stop
on the middle point at last press confirm key.
3,The prompt completion, exit to the standby interface. indicate failure, repeat
steps 1 ~ 2.
Backlight Lamp
The Tone
52
buckle
up
Set: Main Menu → SYSTEM→ VOICE
Set: Main Menu → SYSTEM→ B-LIGHT
natural
natural
t
s
i
w
t
t
w
i
s
t
Endpoint Calibration
Set the backlight mode and time.
Mode:
OFF, no backlight lamp.
ON, duration of bright.
Button, when the button action occurs the light will flash for a period of time.
Time:
key mode, backlight brightness time. 5~60s.
Can set the tone and volume of the remote control device
20 grade volume settings.
The volume is too high so it will influence others, appropriately control volume.
Function Description
To Next Page
Loading...
