27
Check Adjustment Of 1 DT1
The initial , trimming 1 function is the
direction.
Move the fine adjustment to confirm the direction
fine adjustment on the T1 graphics get the
corresponded movement.
Check Adjustment Of 2 DT2
The initial setting, tuning the 2 function is
the throttle trim.
Move the fine adjustment to confirm the throttle
trim move on the T2 graphics.
Check Adjustment Of 3 (DT3)
The initial setting, tuning the 3 function is channel 3 (Ch3).
Move the fine adjustment to confirm the channel 3 (Ch3) on the channel monitor (3) get the
corresponded movement.
Check Adjustment Of 4(DT4)
The initial setting, tuning function is DR(D/
Move the fine tuning to confirm DR numerical changes.
When Installing The Steering Gear In A Model, Proposed The Following
Order To Execute The Function Setting.
1, implement the step from ① to ④ fine adjustment initial setup.
2, set the steering gear, the motor direction In [D/R] .
3, adjust the actuator position.
4, according to their own preferences and habits to set throttle / brake stroke.
5, set the maximum stroke of each channel.
setting
R).
Terms Of Use
Fine-tuning The Initial Setting
4
To Next Page
Loading...
