2. Transformer set up
• Switch the mains electric supply to the transformer
ON and wait to hear the audible beep from the transformer.
T
he light on the transformer will now flash red to indicate
that a Bluetooth
®
connection has not yet been established
• Press and hold the blue test button on the transformer until
the the light flashes red and green to indicate that the
transformer is now in pairing mode.
NOTE: You now have 120 seconds to pair the
transformer to the shower.
13
• Turn on power to the shower using the pull cord.
• This will automatically pair the shower and pump.
3. Configuring the shower
181.604 (IMATCH).qxp_Layout 1 14/10/2019 11:24 Page 13
To Next Page
Loading...