3-8
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug air conditioner or disconnect power.
2. Remove the air conditioner from the win-
dow.
3. Remove the side curtains and the front
grille (see page 3-2 for the procedures).
4. Remove the two power cord green ground
wire screws from the evaporator frame.
5. Remove the electronic control assembly
from the housing (see steps 5 and 6 on page
3-5 for the procedure).
7. Remove the three screws from the control
housing and and remove the housing.
8. Remove the two screws from the capaci-
tor cover, pull the cover forward, and re-
move it.
Control Housing
Capacitor Cover
Screws
6. Disconnect the smooth power cord lead con-
nector from electronic control board termi-
nal L1.
Smooth Power Cord Lead At Terminal L1
REMOVING THE POWER CORD AND CAPACITOR
MODELS ACQ058MM & ACQ062MM
Power Cord Ground Wire Screws
Screw 1 of 3)
To Next Page
Loading...
