To Next PageTo Next PageWhat to do if my Whirlpool AMD 093 runs, but does not cool/hot?
If your Whirlpool Air Conditioner runs but doesn't cool or heat, the filter may be dirty or the air outlet might be blocked. Clean the filter and clear any obstructions from the air outlet. Also, check if the set temperature is appropriate for the mode you are using: in cooling mode, the set temperature should not be too high, and in heating mode, it should not be too low.
How to fix a Whirlpool AMD 093 that does not operate?
If your Whirlpool Air Conditioner does not operate, make sure it is plugged into a grounded outlet. Replace the fuse or reset the circuit breaker. Press the ON/OFF button. Wait for the power to be restored if there was a power outage. Replace the fuse with a time-delay fuse or circuit breaker of the correct capacity.
Why does my Whirlpool Air Conditioner seem to run too much?
Your Whirlpool Air Conditioner might seem to run too much because doors and windows are open. Ensure that doors and windows are closed. If the room is heavily occupied or heat-producing appliances are in use, use exhaust vent fans and avoid using these appliances during the hottest part of the day. In some cases, a higher capacity air conditioner may be required, depending on the size of the room. In case the air conditioner is in a very cool room, a higher capacity air conditioner may be required, depending on the size of the room being heated up.
What to do if my Whirlpool AMD 093 Air Conditioner cycles on and off too much?
If your Whirlpool Air Conditioner cycles on and off too much, the unit might not be properly sized for the room. Check the cooling/heating capabilities of your portable air conditioner. Also, a dirty filter or obstructions can cause this issue, so ensure you clean the filter. In cooling mode, excessive heat or moisture in the room can be the cause, so use a fan to exhaust heat or moisture and avoid using heat-producing appliances during the hottest part of the day. In heating mode, avoid using your air conditioner when the temperature of the environment is too high. Ensure that the louvers are not blocked by curtains, blinds, furniture, etc. Do not try to operate your air conditioner in the cooling mode when the outside temperature is below 18°C.
General| Brand | Whirlpool |
|---|---|
| Model | AMD 093 |
| Category | Air Conditioner |
| Language | English |
Information on recycling packaging materials according to local regulations.
Guidelines for proper disposal of the air conditioner as WEEE.
Key operational points regarding display, mode changes, and compressor behavior.
Instructions for inserting and removing AAA batteries from the remote control.
Guidance on discarding used batteries as sorted municipal waste.
Details on operating modes: Cooling, Dry, Fan Only, and Heating functions.
Instructions for filter reset, temperature adjustment, and fan speed selection.
How to change the temperature display between Celsius and Fahrenheit.
Steps to set the real-time clock and timers for automatic operation.
How to turn the unit on/off and select operating modes via remote.
Explanation of 6th Sense, Jet mode, and fan speed selection.
Guide to temperature adjustment and U button functionality.
How to activate and use Sleep Mode for comfort and energy saving.
Adjusting airflow direction and understanding normal operating sounds.
Instructions for draining, cleaning the filter, and wiping the exterior.
Steps for preparing the unit for storage.
Solutions for unit not operating, fuse trips, short cycles, and insufficient performance.
Addresses issues related to room conditions, temperature settings, and frequent cycling.
Lists the required tools and supplied parts for installation.
Guidelines for choosing an appropriate location and power supply.
How to properly connect and use the power supply cord.
Steps for removing packaging and connecting the exhaust hose and adapter.
Instructions for installing the window slider kit.
How to attach the rain cover for vertical and horizontal windows.
Steps for fitting the slider kit to different window sizes.
How to position the slider kit, secure the sash, and install foam seal.
Steps to take before calling service and information to provide.
