Using your
Product
Night
AIR PURIFYING (Auto)
1. Press “POWER” key to turn on the machine,
lights up.
2. Press “MODE” key until lights up.
3. Under Night mode, fan speed operates at extra low speed. Lover will set at front-up. After 1 minute
operation, the Air Quality
LED* will turn off and the display & other icon will become dim.
4. Press “SWING” key to select vertical louver swing angle.
Air ow front-up front-down
Remarks 1 : When choosing different angle of the louver, louver will be swing to the largest angle for 10 seconds first,
and then move to the selected option.
Remarks 2 : Press the Air flow icon again, louver will stop as is.
5. If necessary, press “TIMER” key to adjust the operation duration 1-12 hours or CO(continuous).
6. If necessary, press “Humidity” key to adjust the humidity level.
1. Press “MODE” key until
lights up.
2. Under Air purifying (Auto) mode , compressor will be stopped and no dehumidify function.
3. The 3-color Air Quality LED lights up according to below condition:
· Green – Air Quality is in good condition
· Orange – Air Quality is in normal condition
· Red – Air Quality is in bad condition
4. Press “SWING” key to select vertical louver swing angle.
Air ow front-up front-down
Remarks 1 : When choosing different angle of the louver, louver will be swing to the largest angle for 10 seconds first,
and then move to the selected option.
Remarks 2 : Press the Air flow icon again, louver will stop as is.
5. Under Air Purifying (Auto) mode , IONIZER Key turns on automatically. You can stop it when
necessary.
6. Under Air Purifying (Auto) mode , Timer can be set.
7. Under Air Purifying (Auto) mode , LED display will show “--”.
Air purifying system is used to remove contaminants and odors from the air in a room. This unit also
includes air purify system which includes Nano Silver Ion filter; All-in-one Multi-Protection
filter
#
, Ionizer and Air Quality LED.
Remark:
• Under Night mode, the fan speed cannot be adjusted
Machine will stop under following situation:
• when the water tank is full (P.43)
• when the temperature or humidity is out of operation range (P.38)
• Press "CO" (continuous)the unit will stop automatically after 48 hours operation. If water
tank was taken out during operation , the counting time will start over again.
Remark:
#All-in-one Multi-Protection filter is applicable to model DS201HB, DS201HW, DS241HB and
DS241HW
• Air Purifying function will be operated automatically under every modes and can not be
switched off.
• Press "CO" (continuous), the unit will stop automatically after 48 hours operation. If water tank
was taken out during operation, the counting time will start over again.
• Under Air Purify (Auto) mode, HUMIDITY cannot be adjusted.
• Under Air Purifying (Auto) mode, fan speed will be operated automatically according to the air
quality level.
• Under Air Purifying (Auto) mode, fan speed cannot be changed manually.
CAUTION
+
+
To Next Page
Loading...
