3. Hold the surface element as level
as possible with the terminal
just started into the receptacle.
4. Push the surface element termi-
nal into the receptacle. When
the terminal is pushed into the
receptacle as far as it will go,
the surface element will fit into
the reflector bowl.
CAUTION: Reflector bowls reflect heat back to the utensils on the
surface elements. They also help catch spills. When they are kept
clean, they reflect heat better and look new longer.
If a reflector bowl gets discolored, some of the utensils may not be
flat enough, or some may be too large for the surface element. In
either case, some of the heat that’s meant to go Into or around a
utensil goes down and heats the reflector bowl. Thls extra heat can
discolor It. See “Cooklng Guide” for further information.
Lift-Up Cooktop
1.
Lift front of cooktop at center and
swing-up the support rod.
2. Carefully lower the cooktop onto
the support rod.
Wipe with warm soapy water.
Use soapy steel-wool pad on
stubborn spots.
CAUTION: Do not drop the cooktop or let It bump the upper oven
when Ilftlng. Damage can result to the porcelain and the cooktop
frame.
1
To Next Page
Loading...
