Whirlpool WOS51EC0H - Accessing the Microwave Magnetron

COMPONENT ACCESS
4-6

Whirlpool
®
Smart Wall Ovens
Accessing the Microwave Magnetron
1. Remove three (3) ¼" (6.4 mm) hex screws from the back
panel and ten (10) ¼" (6.4 mm) hex screws from the side,
then gently place outer panel aside.
2. Remove nine (9) #T10 †Torx
®
screws and four (4) ¼" (6.4 mm)
aside.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
Back to Table of Contents