Troubleshooting Guide for Whirlwind Model 216 Cut-Off
Saw
----------------------------------------------------------------------------
----------------------------------------------------------------------------
Electrical Problems
----------------------------------------------------------------------------
----------------------------------------------------------------------------
1. If reset button must be depressed to re-start machine:
A Check wires
on
magnetic starter.
B. Check wires
to
motor.
C. Check incoming wire connections and voltage.
D.
Verify correct heaters are installed.
2. If machine re-starts by depressing start/stop button:
A.
Check wires to start/stop switch.
B. Check wires to door interlock switch.
C. Follow these wires to box and check connections at box.
NOTE:
1. Closely examine all rubber seals for damage while disassembling valves.
2. Repair kits are available for cylinder and pilot valve.
3.
Do
Not
allE:lw
sawdust or any foreign matter to enter valves or hoses while the machine
is
being serviced.
4.
DO
NOT REMOVE OR TAMPER WITH ANY SAFETY DEVICES.
Page 06
R081303
To Next Page
Loading...
